Settings for the Secure Operation 2 (Initial Settings Procedures Using CentreWare Internet Services)
16
5
6 Click [Apply].
7 Click [SNMP Configuration].
8 Click [Edit SNMP v3 Properties] and check [Account Enabled] for [Administrator Account].
9 Enter a new Authentication Password (minimum 8 characters).
10 Enter the Confirm Authentication Password.
11 Enter a new Privacy Password (minimum 8 characters).
12 Enter the Confirm Privacy Password.
13 Check [Account Enabled] for [Print Drivers/Remote Clients Account].
14 Click [Apply].
Note • Be sure to change Authentication Password and Privacy Password from the default Password.
• In using SNMP v3, use the IPSec protocol simultaneously. You need to set the IP address of the
clients for SNMP v3 according to the procedures in "Set IPSec Address" (P.15), and enter the IP
Address in the [Specify Destination IPv4 Address] or [Specify Destination IPv6 Address] box.
• Since the machine cannot communicate by SNMP v1/v2c, you need to uncheck [SNMP status
Enabled] for the port setting on the client's printer driver.
Set S/MIME
To use E-mail with this machine, the E-mail function needs to be enabled and configured as
described in the Administrator Guide's "8 E-mail Environment Settings".
Before making the S/MIME setting, you need to import an S/MIME certificate according to
the same procedure as "Configuring Machine Certificates" (P.14).
1 Click [Configuration Overview] on the [Properties] screen.
2 Click [Settings] for [E-mail].
3 Click [Configure] for [E-mail Settings], and enter the machine's E-mail address in the [From
Address] box.
4 Click [Apply].
5 Click [Security] on the [Properties] screen.
6 Click [Certificate Management].
7 Select [S/MIME] for [Certificate Purpose].
8 Click [Display the list], and check a desirable certificate.
9 Click [Certificate Details].
10 Click [Use this certificate].
11 Click [SSL/TLS Settings].
12 Check the [Enabled] box for [S/MIME Communication].
13 Click [Apply].
14 Click [Reboot Machine].
15 After the machine is restarted, refresh the browser and click the [Properties] tab.
16 Click [Security].
To Next Page
Loading...
Need help?
General
