15 Problem Solving
596
Problem Solving
15
3 Pull out the staple cartridge.
Note • The staple cartridge is firmly inserted. A slight
force is required to pull the cartridge out of
the finisher.
4 Pull up the metal part of the staple cartridge as
shown in the illustration.
5 Remove the jammed staples (1), and then
return the metal part pulled up in step 5 to the
original position (2).
6 Push the staple cartridge into the machine until
it clicks into place.
7 Close the finisher front door.
Note • If the finisher front door is not completely closed, a message will appear and the machine remains
paused.
If you cannot remove jammed staples even after you perform the above procedure, contact
our Customer Support Center.
Be careful in removing jammed staples.
To Next Page
Loading...
