Fuji Xerox DocuCentre-V C5575

Setup
301
Tools
5
Transfer via SMB (1), Transfer via SMB (2)
Specify where SMB forwarding is to be stored.
[Transfer via SMB (2)] will be displayed when [Transfer via SMB (1)] is configured.
 Address Book
When the server address is registered on the Address Book, you can specify the address from
the Address Book. The specified address appears in the [Transfer via SMB (1)] or [Transfer
via SMB (2)] screen.
For more information on the Address Book, refer to "Add Address Book Entry" (P.303).
 File Format
Specify an output file format.
For more information on the [File Format] screen, refer to "5 Scan" in the User Guide.
 Resend Attempts
Set whether or not to try sending again if a transmission fails. If you select [On], set the
number of resend attempts and interval.

Resend Attempts
Set the transmission retry count from 1 to 5.

Resend Interval
Set the transmission retry interval from 30 to 300 seconds.
 Name, Server, Shared Name, Save in, User Name, and Password
Select [Name], [Server], [Shared Name], [Save in], [User Name], or [Password] to display an
input screen.
The numbers of characters you can input are as follows:

Name: Up to 18 single-byte characters

Server: Up to 64 single-byte characters

Shared Name: Up to 64 single-byte characters

Save in: Up to 128 single-byte characters

User Name:
For domain users: up to 97 characters with the format of "user name@domain name" or
"domain name\user name"
(user name and domain name must be up to 32 and 64 single-byte characters,
respectively)
For local users: up to 32 single-byte characters

Password: Up to 32 single-byte characters
Print
Configure print settings. When [On] is selected, you can configure the settings for the Print
feature.
 Print Quantity
Set the number of copy sets from 1 to 999 in 1 set increments.
 Paper Supply
Select a paper tray for printing. When [Auto Select] is selected, the same paper size as the
document size is used.