Copying Procedure
65
Basic Operation
3
Step 3 Entering a Quantity
You can enter up to 999 sets.
1
Enter the number of copies using the numeric keypad. The number of copies entered
appears on the upper right of the touch screen.
2
If you have entered an incorrect value, press the <C (Clear)> button and then enter the
correct value.
Step 4 Starting the Copy Job
1
Press the <Start> button.
Important • If the document has been loaded in the document feeder, do not hold down the document while it is
being conveyed.
• You can set the next job during copying.
If you have more documents
If you have more documents to copy, select [Next Original] on the touch screen while the
current document is being scanned. This allows you to scan the documents as a single set of
data.
2
Select [Next Original] while scanning is in
progress.
Note • When using the document feeder, load the
next document after the machine has
finished scanning the first document.
• When [Next Original] is displayed on the
screen shown on the right and no operation is
performed for a certain period of time, the
machine automatically assumes that there
are no more documents.
• You can change the number of copies by selecting [Change Quantity] that is displayed after
selecting [Delete].
3
Load the next document.
4
Press the <Start> button.
If you have more documents, repeat steps 3 and 4.
To Next Page
Loading...
Need help?
General
