35
3
3
Control panel 3
LEDs (Light Emitting Diodes) 3
This section refers to two LEDs and one key on the control panel.
1 Power On/Off
You can turn the machine on and off.
Press and hold down to turn the machine on.
Press and hold down to turn the machine off. All the LEDs turn off when you enable the Power Off
mode.
Also, you can use the following functions:
1 Job Cancel / All Jobs Cancel
Error recovery / Form feed
For details, see Power On/Off key on page 40
2 Error LED ( )
The Error LED ( ) indicates that the machine is in error state.
Also, the Error LED ( ) indicates the kind of error in combination with other LEDs.
3 Ready LED ( )
The Ready LED ( ) will blink depending on the machine status.
The LED indications shown in the table below are used in the illustrations in this chapter.
General Information 3
LED is off.
or
LED is on.
LED is dimmed.
or
LED is blinking.
1
2
3
To Next Page
Loading...
Need help?
General
