Electric screwdrivers mentioned in this manual employs a fastening control system which utilizes lock torque
obtained when motor is bound. Thus, applying over-rating load to motor may damage motor.
Fastening load will decided depending on screw size , preparatory hole on workpiece, fastening torque,
fastening tact time, etc. For fastening tact time , the unit usually requires interval of approx. 3 sec for
one-second fastening.
If fastening conditions are decided by user, please be careful to keep surface temperature of screwdriver at
60℃ or less ( in case of room temperature of 20℃ ) , taking heat emission of motor into consideration.
Overcurrent indicator lamp ( OCP )
When an overcurrent lamp turned on by the trouble of the motor. the disconnection of the driver cable.
off does a main switch and can continue it if I do ON 3 sec later.
To Next Page
Loading...