※Be sure to perform inspection and test run before operation start.
Inspection before operation start check if that:
① Driving shaft of screwdriver unit is free from any trouble.
②
Controller is free from any trouble.(Fusing,etc)
③ Each cable is free from any trouble.(Damage,crack,etc)
④ Each cable is connected correctly.
Please drive start of work when you can confirm the check above.
After inspection,perform trial operation to check the unit for trouble.
If any trouble should be found, be sure to repair as soon as possible.
① Set screwdriver select switch in the front of controller in accordance with model No. of
electric screwdriver used.
※MO-1330→133，MO-1350→135（DO-1390A、DO-1390A-2）
【Caution】If screwdriver's model No. does not coincide with the selected No. on the swich,
screwdriver may not work or motor may be burned.
② Set torque knob on controller to desired fastening torque value.
(For torque value, refer to torque chart on page 7.)
③ Turn ON power switch on controller. Then, make sure that power indicator lights.
Stop
Turn OFF power switch on controller and make sure that power indicator goes off.
To Next Page
Loading...