fi-6140 / fi-6240 Image Scanner Operator's Guide
TROUBLESHOOTING
CONTENTS MAP
TOP
2.5 How to Use the Scanner Drivers
To scan documents with the scanner, a scanner driver and application supported by the driver are prerequisites.
This scanner is accompanied with two drivers; one is a TWAIN-compliant driver, FUJITSU TWAIN 32 Scanner Driver, and the
other is an ISIS-compliant driver, FUJITSU ISIS Scanner Driver, and an application named ScandAlll PRO, which supports both
the drivers FUJITSU TWAIN 32 and FUJITSU ISIS.
In this section, how to use these drivers is described.
For information about how to use ScandAll PRO and how to invoke a scanner driver via ScandAll PRO, see Section "
2.6 How to
Use ScandAll PRO."
FUJITSU TWAIN 32 Scanner Driver
The FUJITSU TWAIN 32 Scanner Driver is a driver for scanning documents with the scanner based on a TWAIN-compliant
application.
Usually, you can configure the scanner settings in the scanner driver’s setup dialog box, invoking a scanner driver via an
application. (Depending on the application settings, this setup dialog box may not appear.)
HINT
How to invoke a scanner driver varies depending on the application. For details, refer to the
manual or help of the application you use.
For information about how to invoke a driver via ScandAll PRO, see Section "
2.6 How to Use
ScandAll PRO."
FUJITSU TWAIN 32 Scanner Driver Setup
file:///D|/Documents%20and%20Settings/scanner/Desktop/Lynx3/06/contents/EN/02/c02_05_01.htm (1 of 18)9/28/2007 2:38:14 PM
To Next Page
Loading...
Need help?
General