For information about setting items you can configure, see Section "2.5 How to Use the Scanner Drivers."
How to Scan Documents
With ScandAll PRO, you can scan documents with a scanner, in either of two ways:
Scan
You have to configure settings, such as the file format, destination, and scanning parameters, every time you
scan a document.
Use [Scan] when you want to scan a small amount of documents as necessary.
Batch Scan
You may want to use the same settings repeatedly. You can configure settings such as the file format,
destination, and scanning parameters, image-related properties, and an application to link with and create a
profile with these settings saved.
You can create more than one profile beforehand, so you do not have to configure settings every time you scan
documents. You only switch between profiles.
Use [Batch Scan] when you want to scan a large volume of documents using various profiles.
Scan
1. Place the document on the scanner.
For information about how to place documents, see Section "2.2 Loading Documents on the ADF for Scanning."
file:///D|/Documents%20and%20Settings/scanner/Desktop/Lynx3/06/contents/EN/02/c02_06_01.htm (4 of 15)9/28/2007 2:38:17 PM
To Next Page
Loading...
Need help?
General