Fujitsu AB*G14LVTA - INDOOR UNIT (Setting by Wired Remote Controller)

- (01-164) -
MULTI TYPE 2, 3, 4 ROOMS TYPE MULTI TYPE 2, 3, 4 ROOMS TYPE
INDOOR UNIT (setting by wired remote controller)13-3.
The function settings of the control of the indoor unit can be changed by this procedure

●
according to the installation conditions. Incorrect settings can cause the indoor unit
malfunction.
After the power is turned on, perform the "FUNCTION SETTING" according to the

●
installation conditions using the remote controller.
The settings may be selected between the following two: Function Number or Setting

●
Number.
Settings will not be changed if disable numbers or setting numbers are selected.

●
This function cannot be used on secondary units.

●
PREPARATION

(1) Turn on the power to the Outdoor unit.
Before turning on the power of the indoor units, make sure the piping air-tight test and vacuuming have been ●
conducted.
Also check again to make sure no wiring mistakes were made before turning on the power. ●
Indoor
units
Outdoor unit
Breaker ON