Fujitsu ABUH18LUAS - E: 58.↓. Intake Grille Error (Indoor Unit)

2-16. E: 58.X. Intake grille error (Indoor unit)
Indicator
→ired remote
controller
Error code E: 58
Detective actuator
Indoor unit main PCB
→hen the Micro switch is detected open while running
the compressor.
Micro switch
Forecast of cause
Micro switch failure
Shorted connector/wire
Main PCB failure
Check point 1. Check limit switch
• Check operation of Micro switch. (any blocking by dust, etc.)
• Remove Micro switch and check ON/OFF switching operation by using a meter.
-> If micro switch is detective, replace it.

Check point 2. Check connector (CN11)/wire
Check loose contact of CN11/shorted wire (pinched wire).
-> Replace micro switch if the wire is abnormal

Check point 3. Replace the main PCB
If Check Point 1 and 2 do not improve the symptom, replace the main PCB.

End
2-16. E: 58.↓. Intake grille error (Indoor unit) - (03-22) - 2. Troubleshooting with error code
TROUBLESHOOTING TROUBLESHOOTING