Fujitsu ABYA45LCT - Outdoor Power Factor PCB Assembly

En-13
Indoor unit setting
Jumper wire
Remote control unit
signal code
JM1 JM2
Connect Connect A (Primary setting)
Disconnect Connect b
Connect Disconnect c
Disconnect Disconnect d
Indoor unit
Printed circuit board
10. TEST RUN
CHECK ITEMS
Is operation of each button on the remote control unit (1)
normal?
Does each lamp light normally?(2)
Donotairowdirectionlouversoperatenormally?(3)
Is the drain normal?(4)
Is there any abnormal noise and vibration during opera-(5)
tion?
Do not operate the air conditioner in the running state for a •
long time.
Test running•
When the air conditioner is run by pressing the remote con-
trol unit test run button, the OPERATION and TIMER Lamps
ashslowlyatthesametime.
[Operation method]
For the operation method, refer to the operating manual.•
The outdoor unit may not operate depending on the room •
temperature.
In this case, press the test run button on the remote control
unit while the air conditioner is running. (Point the transmit-
ter section of the remote control unit toward the air condi-
tioner and press the test run button with the tip of a ball-
point pen, etc.)
Transmitter section
Test run button
To end test operation, press the remote control unit START/•
STOP button.
(When the air conditioner is run by pressing the test run but-
ton, the OPERATION Lamp and TIMER Lamp will simulta-
neouslyashslowly.)
9. SELECTING THE REMOTE CONTROL
UNIT SIGNAL CODE
When two or more air conditioners are installed in a room and
the remote control unit is operating an air conditioner other
than the one you wish to set, change the signal code of the
remote control unit to operate only the air conditioner you
wish to set (four selections possible).
When two or more air conditioners are installed in a room,
please contact your retailer to set the individual air conditioner
signal codes.
Conrmthesettingoftheremotecontrolunitsignalcode•
and the printed circuit board setting.
Ifthesearenotconrmed,theremotecontrolunitcannotbe
used to operate for the air conditioner.
Selecting the Remote Control Unit Signal Code
Use the following steps to select the signal code of the remote
control unit.
(Note that the air conditioner cannot receive a signal code if
the air conditioner has not been set for the signal code.)
Press the START/STOP button until only the clock is (1)
displayed on the remote control unit display.
PresstheMODEbuttonforatleastvesecondstodisplay(2)
the current signal code (initially set to ).
Press the SET TEMP. ((3) ) ( ) button to change the
signal code between .
Match the code on the display to the air conditioner signal
code.
Press the MODE button again to return to the clock dis-(4)
play. The signal code will be changed.
If no buttons are pressed within 30 seconds after the signal
code is displayed, the system returns to the original clock
display. In this case, start again from step 1.
The air conditioner signal code is set to A prior to shipment.
Contact your retailer to change the signal code.
The remote control unit resets to signal code A when the
batteries in the remote control unit are replaced. If you use a
signal code other than signal code A, reset the signal code
after replacing the batteries.
If you do not know the air conditioner signal code setting,
try each of the signal codes ( )untilyoundthe
code which operates the air conditioner.
1125-9379122009.indd 13 2008/11/26 7:57:05
www.enindel.com