Fujitsu AOU24RGLX Design & Technical Manual

¢
External heater output
Control Primary heater Auxiliary heater
Function setting
Indoor unit Wired R. C.
Control switching
external heaters
No. 61
Sensor activation*
2
Auxiliary heater
control 1
Heat pump
External device*
1
61-00 —
Auxiliary heater
control 2
Heat pump External device 61-01 —
Heat pump prohibition
control
External device None 61-02 On (Enabled)
Auxiliary heater
control by outdoor
temperature 1
Heat pump External device 61-03 On (Enabled)
Auxiliary heater
control by outdoor
temperature 2
Heat Pump External device 61-04 On (Enabled)
Auxiliary heater
control by outdoor
temperature 3
Heat Pump External device 61-05 On (Enabled)
Auxiliary heat pump
control
External device Heat pump 61-06 On (Enabled)
Auxiliary heat pump
control by outdoor
temperature 1
External device Heat pump 61-07 On (Enabled)
Auxiliary heat pump
control by outdoor
temperature 2
External device Heat pump 61-08 On (Enabled)
Auxiliary heat pump
control by outdoor
temperature 3
External device Heat pump 61-09 On (Enabled)
NOTES:
• After turning off the heater, 3 minutes of standby time is required by next power-on of the
heater.
• For items marked “—” in the table, any of validate or invalidate of the setting are acceptable.
• *1: External device means Hot water, Electrical heater, etc.
• *2: Sensor activation:
– Setting change from the factory setting is required.
– Indoor unit fan setting will be on for safety reason without sensor activation of wired remote
controller.
- 64 -
8-4. Details of function 8. External input and output
DUCT TYPE ARU12-48RGLX DUCT TYPE ARU12-48RGLX

Fujitsu AOU24RGLX Specifications

General

Brand	Fujitsu
Model	AOU24RGLX
Category	Air Conditioner
Language	English