What to do if my Fujitsu AST9UMAD Air Conditioner doesn’t operate at all?
If your Fujitsu Air Conditioner isn't operating, check the following: ensure the circuit breaker hasn't been turned off, verify there hasn't been a power failure, check if a fuse has blown or a circuit breaker has tripped, and confirm the timer isn't in operation.
Why does my Fujitsu AST9UMAD emit mist or steam?
Mist from your Fujitsu Air Conditioner during Cooling or Dry operation results from sudden cooling of room air, causing condensation. During Heating, steam from the outdoor unit occurs when the fan stops for Automatic Defrosting.
Why is my Fujitsu AST9UMAD Air Conditioner emitting mist or steam?
During Cooling or Dry operation, a thin mist may be emitted from the indoor unit due to the sudden cooling of room air, resulting in condensation. During Heating operation, the outdoor unit’s fan may stop, and steam may be seen rising from the unit because of the Automatic Defrosting operation.
Why does my Fujitsu AST9UMAD have weak airflow or stop blowing air?
There are several reasons why the airflow from your Fujitsu Air Conditioner might be weak or stop. When heating operation is started, fan speed is temporarily very low to allow internal parts to warm up. During heating, if the room temperature rises above the thermostat setting, the outdoor unit will stop, and the indoor unit will operate at very low fan speed. The unit will also temporarily stop during heating (between 7 and 15 minutes) for Automatic Defrosting, indicated by a flashing OPERATION lamp. The fan may operate at very low speed during Dry operation or when monitoring the room’s temperature, during SUPER QUIET operation or in the monitor AUTO operation. In Multi-type unit, if multiple units are operated in different operation modes, the units operated afterward will stop and the...
General| Type | Split System |
|---|---|
| Power Supply | 220-240V, 50Hz |
| Refrigerant | R410A |
| Weight (Indoor Unit) | 8 kg |
| Cooling Capacity | 9000 BTU/h |
To Next Page
