Fujitsu ASYG30LMTA User Manual

- 42 -
WALL MOUNTED ASYG30, 36LMTA
4) Room temperature control for wired remote controller sensor
Depending on the installed environment, correction of the wire remote temperature sensor may be
required. Select the appropriate control setting according to the installed environment.
To change this setting, set Function 42 to Both “01”.
Ensure that the Thermo Sensor icon is displayed on the remote controller screen.
5) Auto restart
Enables or disables automatic restart after a power interruption.
NOTE: Auto restart is an emergency function such as for power outage etc. Do not attempt to use
this function in normal operation. Be sure to operate the unit by remote controller or external
device.
6) Room temperature sensor switching
(Only for wired remote controller)
When using the wired remote controller temperature sensor, change the setting to "Both" (01).
00: Sensor on the indoor unit is active.
01: Sensors on both indoor unit and wired remote controller are active.
NOTE: Remote controller sensor must be turned on by using the remote controller.
Function number Setting value Setting description
Factory
setting
35
(For cooling)
36
(For heating)
00 No correction ♦
01 No correction 0.0°C
02 -0.5 °C
More cooling
Less heating
03 -1.0 °C
04 -1.5 °C
05 -2.0 °C
06 -2.5 °C
07 -3.0 °C
08 -3.5 °C
09 -4.0 °C
10 +0.5 °C
Less cooling
More heating
11 +1.0 °C
12 +1.5 °C
13 +2.0 °C
14 +2.5 °C
15 +3.0 °C
16 +3.5 °C
17 +4.0 °C
Function number Setting value Setting description Factory setting
40
00 Enable ♦
01 Disable
Function number Setting value Setting description Factory setting
42
00 Indoor unit ♦
01 Both

Fujitsu ASYG30LMTA Specifications

General

Brand	Fujitsu
Model	ASYG30LMTA
Category	Air Conditioner
Language	English