Fujitsu AU*A45LCLU - WIRED REMOTE CONTROLLER SETTINGS

- (01 - 38) -
CASSETTE TYPE AU

A45-54LC
CASSETTE TYPE AU

A45-54LC
WIRED REMOTE CONTROLLER12-3.
SWITCH POSITION

DIP SWITCH SETTING

1. Dual remote controller setting
Set the remote controller DIP switch No.2 according to the following table.
2. Memory backup setting
Set to ON to use batteries for the memory backup. If batteries are not used, all of the settings
stored in memory will be deleted if there is a power failure.
DIP SW
1 Can not be used. (Do not change)
2 Dual remote controller setting
3 Can not be used. (Do not change)
4 Can not be used. (Do not change)
5 Can not be used. (Do not change)
6 Memory backup setting
ON
ON
OFF
1
2
3
4
5
6
Front case (back side)
Do not use this
DIP Switch
DIP Switch
(

Factory setting)
Number
of remote
controller
Master unit Slave unit
DIP-SW No.2 DIP-SW No.2

1 (Normal) OFF
―
2 (Dual) OFF ON
(

Factory setting)
DIP-SW
No.6
Memory backup

OFF Invalidity
ON Validity