5
Prompts to change remote control's batteries
● Remote control periodically starts and stops.
Battery Indicator Display (Fig.6 V) shown during operations.
• At start-up: blinks 5 times
• At shut-down: remains lit for about 10 minutes.
If the Battery Indicator Display is shown, please change your batteries as soon as
possible, even if your remote control is still usable.
Open gently (do not be
too rough).
About the TEST RUN button
● This button is used when installing the air conditioner and should not be used
under normal conditions, as it will cause the air conditioner’s thermostat func-
tion to operate incorrectly.
● If this button is press during normal operation, the unit will switch to the test
operation mode and the OPERATION Indicator Lamp (red) (Fig.2 6) and TIMER
Indicator Lamp (green) (Fig.2 5) on the Indoor Unit will flash simultaneously.
● To the stop the test operation mode, press the START/STOP button (Fig.5 Y) to
stop the air conditioner.
About the Compulsory Cooling Mode
● If the TEST RUN button (Fig.5 q) is pressed during the cooling mode, the unit will change to the compulsory cooling mode
and the room will be cooled regardless of the thermostat setting.
● Use the compulsory cooling mode to collect refrigerant in the outdoor unit before moving the air conditioner. (Do not use
this button under normal conditions.)
TEST RUN button
PREPARATION
Take hold of both sides
of the cover, and insert
the cover into its place
until you hear a click.
How to open and close the remote control's cover.
To Next Page
Loading...
Need help?
General
