Working with the notebook
Connecting the mains adapter to the Port Replicator
Make sure that the correct AC adapter is connected: Output: 19.5 V / 19.6 A (330 W).
1
3
3
2
► Connect the power cable to the mains adapter (1).
► Plug the power cable into the mains socket (2).
► Connect the mains adapter cable to the DC jack (DC IN) of the Port Replicator(3).
When the notebook is connected to a Port Replicator, the operating system creates
a hardware profile for the "Docked" mode. In this profile, for example, the setting is
saved as to which monitor was last used for output. This profile will be loaded, as
soon as the notebook is connected to a Port Replicator of the same type.
46 Fujitsu
To Next Page
Loading...
