31
2 Remove the screw (1).
3 Remove the rear slot cover plate from the slot (2).
Do not dispose of the cover plate. For cooling, protection against fire and in order to comply
with EMC regulations, you must refit the cover plate if you remove the board.
4 Take the new board out of its packaging.
5 Make the required settings for the board.
6 Push the board up to its slot (3).
Ensure that the end of a long board without angle bracket fits into the corresponding
guide of the system unit.
7 Press the board into the slot so that it engages.
8 Fix the board with the screw (4).
9 If necessary, connect the cables.
10 Close the system unit (see "Assembling the system unit").
If you have installed or removed a PCI board, please check the relevant PCI slot settings in
the BIOS Setup. If necessary, change the settings. Further information is provided in the PCI
board documentation.
Installing a board
1 Open the system unit (see "Opening the system unit").
1
2
3
4
CHAPTER 4 Martini2 (27-44) 12/21/01, 10:15 AM31
To Next Page
Loading...
