32
3 Remove the screw (1).
4 Remove the board from the system unit (2).
5 Place the board into appropriate packaging.
CAUTION
To ensure proper cooling, fire protection and observation of the relevant EMC
(electromagnetic compatibility) regulations, you must mount a rear slot cover plate.
6 Push the rear slot cover plate into the slot (3).
7 Fasten the rear slot cover plate with the screw (4).
8 Close the system unit (see "Assembling the system unit").
If you have installed or removed a PCI board, please check the relevant PCI slot settings
in the BIOS Setup. If necessary, change the settings. Further information is provided in the
PCI board documentation.
Removing a board
1 Open the system unit (see "Opening the system unit").
2 Disconnect the cables connected to the board.
1
2
3
4
CHAPTER 4 Martini2 (27-44) 6/12/02, 1:37 PM32
To Next Page
Loading...
