40
1
1
3 Fasten the drive with the four screws in the installation frame.
4 Install the installation frame with the drive in the desired 5
1
/4" slot (see "Installing an
accessible drive").
5 Close the slot with the panel. Ensure that the cover engages.
6 Close the system unit (see "Assembling the system unit").
3 Fasten the hard disk carrier with the screw (4).
4 Close the system unit (see "Assembling the system unit").
It may be necessary to modify the entry for the drive in the BIOS Setup.
Mounting a hard disk drive in a 5
1
/4" slot
To do this, you require a special mounting frame.
1 Open the system unit (see "Opening the system unit").
2 Make the required settings (e.g. master-slave) on the hard disk drives.
CHAPTER 4 Martini2 (27-42) 6/12/02, 1:39 PM40
To Next Page
Loading...
