Fujitsu DL3750+/3850+ - Unpacking and Inspecting Printer Components

SETTING UP
User's Manual 2-3
Quick
Reference
Introduction
Setting Up
P
aper
Handling
Printing
Setup Mode
UNPACKING THE PRINTER Unpack the printer as follows:
1. Open the carton and remove the printer and its components. Make
sure that you have all of the items shown below. Note that the power
cord supplied depends on the printer model (100-120 or 220-240 VAC
power supply).
Ribbon cartridge
(Black)
Cut sheet stand
Printer
Power cord Setup disk
Checking items received