Need help?Do you have a question about the Fujitsu ETERNUS DX500 S4 and is the answer not in the manual?
General| Model | ETERNUS DX500 S4 |
|---|---|
| Category | Storage |
| Form Factor | 3U |
| Drive Types Supported | SSD, SAS, Nearline SAS |
| RAID Levels Supported | 0, 1, 5, 6, 10 |
| Host Interfaces | iSCSI, Fibre Channel, SAS |
| Drive Bays | 2.5-inch and 3.5-inch |
| Host Interface Speed | 16 Gbps Fibre Channel, 10 Gbps iSCSI/FCoE, 12 Gbps SAS |
| Power Supply | Redundant power supplies |
| Operating Humidity | 20 to 80% (non-condensing) |
Details powering the ETERNUS DX system on and off.
Describes using setting change switches for maintenance tasks.
Describes viewing ETERNUS DX status using the Web GUI.
Explains checking ETERNUS DX status using the ETERNUS CLI.
Provides a checklist for common ETERNUS DX operational issues.
Lists information needed for maintenance engineers during troubleshooting.
To Next Page
