Need help?Do you have a question about the Fujitsu ETERNUS DX60 S4 and is the answer not in the manual?
Details components and LEDs of controller enclosures, including front and rear views.
Details components and LEDs of drive enclosures, including front and rear views.
Describes 1U and 2U power distribution units and their outlets.
Explains how to turn the ETERNUS DX system on and off using the power switch.
Details how to operate the FUNCTION button for system status changes and settings.
How to check system status, RAID groups, and usage via the ETERNUS Web GUI.
How to check system status and usage through ETERNUS CLI commands.
How to configure event notifications for errors and system events.
How to set up and use audit logs to record operations and system actions.
Step-by-step procedure for installing new drives into the ETERNUS DX.
Step-by-step procedure for installing new drive enclosures into the ETERNUS DX.
Steps for connecting new servers, including RAID group, volume creation, and host affinity.
Emphasizes the importance of regular data backups for system reliability.
Provides information on maintenance service procedures and engineer requirements.
Details the procedure and cycle for replacing expendable batteries.
How to check battery replacement time and its impact on performance.
A comprehensive list of common issues and checks for resolving ETERNUS DX errors.
Guides on troubleshooting power-on failures and incorrect LED indications.
Troubleshoots problems with network connectivity and ETERNUS DX services.
Addresses slow I/O access, performance degradation, and server volume recognition problems.
Overview of the procedure for replacing server HBAs due to FC card failure.
To Next Page
General