Need help?Do you have a question about the Fujitsu ETERNUS DX200 S4 and is the answer not in the manual?
General| Model | ETERNUS DX200 S4 |
|---|---|
| Category | Storage |
| Drive Types Supported | SAS, Nearline SAS, SSD |
| RAID Levels | 0, 1, 5, 6, 10 |
| Host Interfaces | 8/16 Gbps FC, 1/10 Gbps iSCSI, 12 Gbps SAS |
| Controller | Dual Controller |
| Form Factor | 2U |
| Drive Bays | Up to 240 |
| Maximum Number of Drives | Up to 480 |
| Power Supply | Redundant power supplies |
| Operating Humidity | 20% to 80% (non-condensing) |
| Operating Temperature | 5°C to 35°C (41°F to 95°F) |
Details the components and physical layout of the ETERNUS DX controller enclosures.
Provides detailed steps for powering the ETERNUS DX system on and off.
Explains how to install new drives into the ETERNUS DX system.
Details the procedure for installing additional drive enclosures.
Covers preparation and configuration steps for adding new servers to ETERNUS DX.
Explains the procedures and requirements for ETERNUS DX maintenance service.
Offers a checklist of common problems and initial troubleshooting steps.
To Next Page