Fujitsu ETERNUS DX User Manual

FUJITSU Storage
ETERNUS DX, ETERNUS AF
Configuration Guide -Server Connection-
(Fibre Channel) for Oracle Solaris
Driver Settings for Non-Fujitsu Fibre Channel Cards
P3AM-6312-18ENZ0

Fujitsu ETERNUS DX Specifications

General

Management Software	ETERNUS SF
Model	ETERNUS DX
Category	Storage
Drive Types Supported	SSD, SAS HDD, NL-SAS HDD
RAID Levels	RAID 0, 1, 5, 6, 10
Connectivity	FC, iSCSI, SAS
Form Factor	Rack-mountable
Data Reduction	Deduplication, Compression
Scalability	Modular expansion
Support for Flash Storage	Yes
Maximum Capacity	Varies by model within the DX series. Can range from several TBs to multiple PBs.

Summary

Chapter 1 Operations When Using Oracle Fibre Channel Cards

1.2 Installing the Fibre Channel Card Driver

Details the steps to install the Fibre Channel card driver for Oracle cards.

1.3 Setting Up the Server

Explains server setup procedures, including configuration files for different card types.

1.4 Setting Up the Server to Recognize the Logical Units

1.5 Required Driver Parameters

Lists and explains the necessary driver parameters for Emulex Fibre Channel cards.

Chapter 2 Setup Procedure for Emulex Fibre Channel Cards

2.2 Installing the Fibre Channel Card Driver

Details driver installation for Emulex Fibre Channel cards based on OS versions.

2.3 Setting Up the Server

Explains server setup and configuration for Emulex Fibre Channel cards.

2.4 Setting Up the Server to Recognize the Logical Units

2.5 Required Driver Parameters

Lists and explains the necessary driver parameters for Emulex Fibre Channel cards.

Chapter 3 Setup Procedure for QLogic Fibre Channel Cards

3.2 Installing the Fibre Channel Card Driver

3.3 Setting Up the Server

3.4 Setting Up the Server to Recognize the Logical Units

3.5 Required Driver Parameters

Chapter 4 Operations When Using Brocade Fibre Channel Cards

4.2 Installing the Fibre Channel Card Driver

4.3 Setting Up the Server

4.4 Setting Up the Server to Recognize the Logical Units