Fujitsu ETERNUS DX - Chapter 1 Operations When Using Oracle Fibre Channel Cards

Chapter 1
Operations When Using Oracle Fibre Channel
Cards
This chapter describes the procedures for "Installing the Driver and Setting Up the Server" and "Recognizing
the Logical Units" required to establish a connection between a server with Oracle Fibre Channel cards and
an ETERNUS DX/AF.
1.1 Workflow
Workflow
Installing the Fibre Channel Card Driver
Install the driver. Download the proper driver from the Oracle web-site as required.
•
"1.2 Installing the Fibre Channel Card Driver" (page 7)
•
Used for driver installation
-
Driver (downloaded from the Oracle web-site)
Creating Various Management Tables
Enter necessary information in "WWN Instance Management Table for the Server".
•
"1.3 Setting Up the Server" (page 8)
•
"Appendix A Various Management Table Templates" (page 82)
Editing the Configuration File
Set the driver parameters by editing the configuration file.
•
"1.3 Setting Up the Server" (page 8)
•
"1.5 Required Driver Parameters" (page 20)
•
Checking the Oracle driver notes
-
"Configuration Guide -Server Connection- (Fibre Channel) for Oracle Solaris"
6
FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide -Server Connection- (Fibre Channel) for Oracle Solaris
Copyright 2017 FUJITSU LIMITED
P3AM-6312-18ENZ0