Fujitsu ETERNUS DX - For Driver Versions V6.30 G and Later

2.5.1 For Driver Versions V6.30g and Later
Edit the configuration file according to the following parameter list.
2.5.1.1 lpfc.conf Parameter Values
Parameter
Setting value
(for direct connection)
Setting value
(for switch connec-
tion)
lpfcX
(Instance name)
Remarks
log-verbose 0x0 0x0 — —
log-only 1 1 — —
enable-auth 0 0 — —
auth-cfgparms N/A N/A — —
auth-keys N/A N/A — —
lpfcX-fcp-bind-method 4 2 Yes —
fcp-bind-WWNN Not required Not required — —
lpfcX-fcp-bind-WWPN Not required (*1) Yes —
fcp-bind-DID Not required Not required — —
lpfcX-automap 1 0 Yes
•
When setting fcp-
bind-WWPN, set to
"0".
•
When not setting
fcp-bind-WWPN, set
to "1".
lun-queue-depth Arbitrary (*2)
(Up to 512 for each FC
port of the ETERNUS
DX/AF)
Arbitrary (*2)
(Up to 512 for each FC
port of the ETERNUS
DX/AF)
— —
tgt-queue-depth 512 512 — —
lpfcNtM-lun-throttle Not required Not required — —
lpfcNtM-tgt-throttle Not required Not required — —
no-device-delay 0 0 — —
network-on 0 0 — —
xmt-que-size 256 256 — —
lpfcX-scan-down 1 0 Yes —
linkdown-tmo 30 30 — —
nodev-holdio 0 0 — —
nodev-tmo 40 40 — —
delay-rsp-err 0 0 — —
num-iocbs 256 256 — —
num-bufs 128 128 — —
lpfcX-topology 4 2 Yes —
ip-class 3 3 — —
fcp-class 3 3 — —
use-adisc 0 0 — —
Chapter 2 Setup Procedure for Emulex Fibre Channel Cards
2.5 Required Driver Parameters
41
FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide -Server Connection- (Fibre Channel) for Oracle Solaris
Copyright 2017 FUJITSU LIMITED
P3AM-6312-18ENZ0