Fujitsu ETERNUS DX - 1.2 Installing the Fibre Channel Card Driver

Setting Up the Server to Recognize the Logical Units (LUNs)
Make the server recognize the ETERNUS DX/AF logical units using the ssd driver.
•
"1.4 Setting Up the Server to Recognize the Logical Units" (page 17)
After completing all the required procedures in this manual, proceed to "Setting the Multipaths" in
"Configuration Guide -Server Connection- (Fibre Channel) for Oracle Solaris".
1.2 Installing the Fibre Channel Card Driver
Install the Fibre Channel card driver.
Required procedure varies depending on the Solaris OS version.
Refer to the following Oracle web-site for installation procedures.
https://www.oracle.com/
•
Solaris 11 OS or Solaris 10 OS
Driver installation is not necessary because the OS-bundled driver is used.
•
Solaris 9 OS or Solaris 8 OS
Download and install the appropriate driver from the Oracle web-site.
Chapter 1
Operations When Using Oracle Fibre Channel Cards
1.2 Installing the Fibre Channel Card Driver
7
FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide -Server Connection- (Fibre Channel) for Oracle Solaris
Copyright 2017 FUJITSU LIMITED
P3AM-6312-18ENZ0