Fujitsu ETERNUS DX - Emlxs.conf Parameter List

1.5.2 emlxs.conf Parameter List
Parameter
Setting value
(for direct connection)
Setting value
(for switch connec-
tion)
emlxsX
instance name
Remarks
num-iocbs 1024 1024 — —
ub-bufs 1000 1000 — —
network-on 1 1 — —
emlxsX-topology 4 2 (*1) Yes An instance name is
specified for each in-
stance.
emlxsX-link-speed 2, 4, or 8 0, 2, 4, or 8 (*1) Yes An instance name is
specified for each in-
stance (*2).
ack 0 0 — —
cr-delay 0 0 — —
cr-count 1 1 — —
assign-alpa 0x00 0x00 — —
adisc-support 1 1 — —
pm-support 0 0 — —
num-nodes 0 0 — —
*1: Specify "2" for "emlxsX-topology" and "0" for "emlxsX-link-speed" when using direct connections to
16Gbit/s Fibre Channel cards with a transfer rate of 16Gbit/s.
*2: "emlxsX-link-speed" setting value
Fibre Channel
card transfer
rate
Switch connection
Fibre Channel switch transfer rate
Direct connection
CA transfer rate
16Gbit/s 8Gbit/s 4Gbit/s 2Gbit/s 8Gbit/s 4Gbit/s
16Gbit/s 0 8 4 — — —
8Gbit/s 8 8 4 2 8 4
4Gbit/s 4 4 4 2 4 4
2Gbit/s — 2 2 2 2 2
Chapter 1 Operations When Using Oracle Fibre Channel Cards
1.5 Required Driver Parameters
22
FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide -Server Connection- (Fibre Channel) for Oracle Solaris
Copyright 2017 FUJITSU LIMITED
P3AM-6312-18ENZ0