•
T_ID
The SCSI target ID (decimal value) that is to be defined for each CA (check using ETERNUS Web GUI or ETER-
NUSmgr)
For switch connections, the SCSI target ID is irrelevant to the physical protocol, however it must be defined
as a Solaris OS SCSI driver setting. Values matched to the server environment and connection state of the
devices must be set beforehand.
It is recommended to set the same target ID to CAs that configures a multipath.
3.3.3 Creating a Target Binding Table
This procedure is not necessary for direct connections.
Target binding logically binds the Fibre Channel card installed in the server, and the CA on the ETERNUS
DX/AF storage systems to be connected to the server.
Target binding binds the instance name of the Fibre Channel card, channel adapter name, WWN, and target
ID.
Enter the required information for target binding in the "target binding table". Create "Target binding tables"
for each server to be connected.
Enter the following information in the target binding table.
•
Name of target server
•
Channel Adapter names and their SCSI target IDs
The "channel adapter names" and "target IDs" entered in the "WWN instance management table for stor-
age system"
•
RAID-WWN
The WWN entered in the "WWN instance management table for storage system"
1 Enter the target information to be set for the server.
Reflect the information from the "WWN instance management table for storage system" in the "target
binding table".
Example:
Channel Adapter name WWN T_ID Instance name
CM0CA0Port0 202000e000cb0001 16
CM1CA0Port0 203000e000cb0001 16
2 Confirm the connection path(s) in the system.
Example:
Server#0
Slot0
Slot1
CA0 Port0
CM0
CA0 Port1
ETERNUS DX/AF
Fibre Channel Switch A Fibre Channel Switch B
CM1
CA0 Port1 CA0 Port0
Chapter 3
Setup Procedure for QLogic Fibre Channel Cards
3.3 Setting Up the Server
61
FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide -Server Connection- (Fibre Channel) for Oracle Solaris
Copyright 2017 FUJITSU LIMITED
P3AM-6312-18ENZ0
To Next Page
Loading...
