1.4.2 For Switch Connection
Use the following commands to enable the server to access the logical units.
1 Execute the following commands to check the path of the ETERNUS DX/AF to be connected.
# cfgadm -al
Example:
# cfgadm -al
Ap_Id Type Receptacle Occupant Condition
c4 fc-fabric connected unconfigured unknown
c4::21ff00e000a8ffaf disk connected unconfigured unknown
c5 fc-fabric connected unconfigured unknown
c5::25ff00e000a8ffaf disk connected unconfigured unknown
2 Use the following command for each path obtained in Step 1.
Repeat this step for all paths to be used.
# cfgadm -c configure
The underlined portion indicates the path obtained in Step 1.
Example:
# cfgadm -c configure c4::21ff00e000a8ffaf
# cfgadm -c configure c5::25ff00e000a8ffaf
3 Use the following command to confirm that the paths to the ETERNUS DX/AF are now usable.
"Occupant" status changes from "unconfigured" to "configured".
# cfgadm -al
# cfgadm -al
Ap_Id Type Receptacle Occupant Condition
c4 fc-fabric connected configured unknown
c4::21ff00e000a8ffaf disk connected configured unknown
c5 fc-fabric connected configured unknown
c5::25ff00e000a8ffaf disk connected configured unknown
The underlined portion indicates that the ETERNUS DX/AF CA (WWN:25ff00e000a8ffaf) is connected to
the Fibre Channel card port with controller number "c5".
Chapter 1
Operations When Using Oracle Fibre Channel Cards
1.4 Setting Up the Server to Recognize the Logical Units
19
FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide -Server Connection- (Fibre Channel) for Oracle Solaris
Copyright 2017 FUJITSU LIMITED
P3AM-6312-18ENZ0
To Next Page
Loading...
