1 Use the following command to confirm that the storage system has been correctly recognized.
# cfgadm -al
# cfgadm -al
Ap_Id Type Receptacle Occupant Condition
c4 fc-private connected configured unknown
c4::21ff00e000a8ffaf disk connected configured unknown
c5 fc-private connected configured unknown
c5::25ff00e000a8ffaf disk connected configured unknown
The underlined portion indicates that the ETERNUS DX/AF CA (WWN:25 ff00e000a8ffaf) is connected to
the Fibre Channel card port with controller number "c5".
2 Use the following command to confirm that the storage system and all the logical units have been cor-
rectly recognized.
# format
# format
Searching for disks...done
c4t16d0: configured with capacity of 7.98GB
c4t16d1: configured with capacity of 7.98GB
c5t16d0: configured with capacity of 7.98GB
c5t16d1: configured with capacity of 7.98GB
AVAILABLE DISK SELECTIONS:
0. c1t0d0 <SUN36G cyl 24620 alt 2 hd 27 sec 107>
/pci@8,600000/SUNW,qlc@2/fp@0,0/ssd@w21000004cf6851ce,0
1.
c4t16d0 <FUJITSU-ETERNUS_DX8000 cyl 1022 alt 2 hd 64 sec 256>
/pci@9,600000/SUNW,qlc@1/fp@0,0/ssd@w21ff00e000a8ffaf,0
2. c4t16d1 <FUJITSU-ETERNUS_DX8000 cyl 1022 alt 2 hd 64 sec 256>
/pci@9,600000/SUNW,qlc@1/fp@0,0/ssd@w21ff00e000a8ffaf,1
3. c5t16d0 <FUJITSU-ETERNUS_DX8000 cyl 1022 alt 2 hd 64 sec 256>
/pci@9,600000/SUNW,qlc@2/fp@0,0/ssd@w25ff00e000a8ffaf,0
4. c5t16d1 <FUJITSU-ETERNUS_DX8000 cyl 1022 alt 2 hd 64 sec 256>
/pci@9,600000/SUNW,qlc@2/fp@0,0/ssd@w25ff00e000a8ffaf,1
Specify disk (enter its number):
The underlined portion indicates that the ETERNUS DX8100/DX8400/DX8700 target ID=16, lun=0 and 1
are connected to physical path /pci@9,600000/SUNW,qlc@1, and that c4t16d0 and c4t16d1 are as-
signed to each of these LUNs.
Chapter 1
Operations When Using Oracle Fibre Channel Cards
1.4 Setting Up the Server to Recognize the Logical Units
18
FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide -Server Connection- (Fibre Channel) for Oracle Solaris
Copyright 2017 FUJITSU LIMITED
P3AM-6312-18ENZ0
To Next Page
Loading...
