Fujitsu ETERNUS DX - Creating a WWN Instance Management Table for Storage System

(6) Enter "4" to select "4: Return to Previous Menu".
The Main Menu reappears.
Main Menu
1: Display System Information
2: Display HBA Settings
3: Display HBA Information
4: Display Device List
5: Display LUN List
6: Configure HBA Settings
7: Target Persistent Binding
8: Selective LUNs
9: Boot Device Settings
10: Driver Settings
11: HBA Utilities
12: Flash Beacon
13: Diagnostics
14: Statistics
15: Help
16: Quit
(7) Enter "16" to quit.
Enter choice => 0
#
4 Add the results in the "WWN instance management table for the server".
Example:
Physical slot name WWN Instance name Physical path name
21-00-00-E0-8B-91-D9-4F hba0 /pci@b,2000/QLGC,qla@2
21-01-00-E0-8B-91-D9-4F hba1 /pci@b,2000/QLGC,qla@2,1
3.3.2 Creating a WWN Instance Management Table for Storage System
Create a "WWN instance management table for storage system" that summarizes information relating to CA
in the ETERNUS DX/AF storage systems.
When there are two ports on the ETERNUS DX/AF storage systems:
Channel Adapter
WWN T_ID
CM0CA0Port0 202000e000cb0001 16
CM1CA0Port0 203000e000cb0001 16
Check the following items and enter them in the WWN instance management table for storage system.
•
Channel Adapter
CA name in the ETERNUS DX/AF storage systems
•
WWN
The WWN for each CA in the ETERNUS DX/AF (check using ETERNUS Web GUI or ETERNUSmgr)
Chapter 3
Setup Procedure for QLogic Fibre Channel Cards
3.3 Setting Up the Server
60
FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide -Server Connection- (Fibre Channel) for Oracle Solaris
Copyright 2017 FUJITSU LIMITED
P3AM-6312-18ENZ0