Fujitsu ETERNUS DX - Chapter 3 Setup Procedure for QLogic Fibre Channel Cards

Chapter 3
Setup Procedure for QLogic Fibre Channel Cards
This chapter describes the procedures for "Installing the Driver and Setting Up the Server" and "Recognizing
the Logical Units" required to establish a connection between a server with QLogic Fibre Channel cards and
an ETERNUS DX/AF.
3.1 Workflow
Workflow
Installing the Fibre Channel Card Driver
Install the driver. Download the proper driver from the QLogic web-site as required.
•
"3.2 Installing the Fibre Channel Card Driver" (page 55)
•
Driver (downloaded from web-site)
•
Driver product manual
•
Used for driver installation
-
"SANsurfer FC HBA CLI Application" (downloaded from web-site)
Creating Various Management Tables
Enter the necessary information in the "WWN Instance Management Table for the Server", "WWN In-
stance Management Table for Storage System", and "Target Binding Table".
•
"3.3 Setting Up the Server" (page 55)
•
"Appendix A Various Management Table Templates" (page 82)
Editing the Configuration File
Set the driver parameters by editing the configuration file.
•
"3.3 Setting Up the Server" (page 55)
•
"3.5 Required Driver Parameters" (page 66)
54
FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide -Server Connection- (Fibre Channel) for Oracle Solaris
Copyright 2017 FUJITSU LIMITED
P3AM-6312-18ENZ0