Fujitsu Eternus DX600 S3 - Chapter 2 Setting up the ETERNUS DX; Common Settings; Setting the To-Server Connection Type (Setting the Fcoe Port Parameters); Creating the Server Accessible LUN Groups (Setting the LUN Groups)

To Next Page

To Previous Page

Chapter 2

Setting Up the ETERNUS DX

2.1 Common Settings

This section explains the settings required for all server OSes, regardless of the connection configuration.

See the "ETERNUS Web GUI User's Guide" for details of how to set up and operate ETERNUS Web GUI.

2.1.1 Setting the To-server Connection Type (Setting the FCoE Port Parameters)

For each connection configuration, set the indicated items only. All other parameters should be left on their

default values.

Table 2.1 FCoE port parameter settings

Parameter

Solaris OS, Windows

, Linux, VMware ESX

Transfer Rate 10 Gbit/s

Frame Size 2048 bytes (Default value)

Reset Scope I_T_L

Release Reservation if Chip is Reset Disable

Make sure to prepare and set up FCoE switches. For further details, refer to "Fabric OS Administrator’s

Guide Supporting Fabric OS".

2.1.2 Creating the Server Accessible LUN Groups (Setting the LUN Groups)

Create LUN groups (Affinity Group) for the server to access. Refer to "Connectivity Management" in "ETERNUS

Web GUI User's Guide" for details, and set the LUN groups.

When the server OS is Windows

, Linux, or VMware ESX, assign LUN Group values starting from LUN0 in

ascending order. The server cannot recognize the ETERNUS DX LUNs unless they are assigned in this order.

This restriction does not apply when the server is running a Solaris OS.

FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection-

P3AM-7982-05ENZ0

Other manuals for Fujitsu Eternus DX600 S3