12
ETERNUS DX80 S2/DX90 S2 Disk storage system Read Me First
Copyright 2013 FUJITSU LIMITED
P3AM-4872-11EN
Use ETERNUS Web GUI to perform a basic setup of the ETERNUS DX Disk storage system.
Connect a PC terminal to the ETERNUS DX Disk storage system.
Connect the PC terminal to the MNT port of Controller 0 (CM#0) on the controller enclosure directly with the LAN
cable (for operation management).
Turn on the PC terminal and the ETERNUS DX Disk storage system.
Controller enclosure
Drive enclosure
Drive enclosure
Power switch
LAN port
PC terminal
LAN cable
MNT port of Controller 0 (CM#0)
Controller enclosure
ETERNUS DX Disk Storage System and PC Terminal Connection
Basic Setup
STEP
Powering On
Connect the power cords to the inlets of the power supply unit.
Use release ties to hold the power cords in place.
Drive enclosure 1
Controller enclosure
Rear viewCable
Power Cords
-Installation- "4.5 Power Cord Connection"
●
When the LAN cable for the MNT port of Controller 0 (CM#0) is connected to a network device, connect the
cable to a PC terminal.
●
Remove the LAN cable that is connected to the MNT port of Controller 1 (CM#1).
IMPORTANT
-Installation- "5.1.1 ETERNUS DX Disk Storage System and PC Terminal Connection"
-Installation- "5.1.2 Powering On"
When turning on the ETERNUS DX Disk
storage system for the first time, volume
formatting operation, which is set as factory
default, may be performed. However, the
ETERNUS DX Disk storage system setting
operation can be continued.
IMPORTANT
To Next Page
Loading...
