Fujitsu Eternus DX80 S2 - Page 8

8
ETERNUS DX80 S2/DX90 S2 Disk storage system Read Me First
Copyright 2013 FUJITSU LIMITED
P3AM-4872-11EN
1.
Adjust the rack rail size to fit the rack.
The rack rail needs to be attached to the rack and the controller enclosure or the drive enclosure needs to be
installed.
Front view Rear view
2U
[Right][Left]
6th position
(M5 centering screw)
2U
[Right][Left]
6th position
(M5 centering screw)
1st position
(M5 pan head screw)
1st position
(M5 pan head screw)
Base line
Rack rails
Base line
Rack rails
5th position
(M5 centering screw)
5th position
(M5 centering screw)
2nd position
(M5 pan head screw)
2nd position
(M5 pan head screw)
The M5 screw positions for the rack rails are determined by the controller enclosure or the drive enclosure base
line.
Insert the M5 screws in the 1st and 6th holes on the front rack pillars above the base line and in the 2nd and 5th
holes on the rear rack pillars above the base line to fasten the rack rails.
2.
Attach the rack rails to the rack.
The size of the controller enclosure and each drive enclosure is 2U.
Installation in a Rack
STEP
●
Drive enclosures must be installed above the controller enclosure. When installing multiple drive enclosures,
install them in the order of the "DE_No. label" numbers that are attached to the drive enclosures.
The DE_No. labels are attached on the following locations.
●
The center of gravity must be taken into consideration to prevent a rack from toppling over. The controller
enclosure and drive enclosures should generally be installed from bottom to top to lower the center of
gravity and to ensure the safe use of racks.
IMPORTANT
DE_No. labels
Right front side of the drive enclosure Upper rear side of the drive enclosure
-Installation- "Chapter 3 Rack Installation"
[Right]
[Left]
(Front rack pillars)
(Rear rack pillars)
Rack rail (for right side)
Rack rail (for left side)
Washers
M5 screws
M5 screws
Washers
M5 screws
Plate
M5 screws
Plate