Fujitsu Eternus DX90 S2 - Page 6

6
ETERNUS DX80 S2/DX90 S2 Disk storage system Read Me First
Copyright 2013 FUJITSU LIMITED
P3AM-4872-11EN
□
SSD
Installed in the controller enclosure or the drive enclosure.
●
2.5inch
●
3.5inch
SSD (Product ID: ETCS
a b c
, ETES
a b c
(*1)
)
*1: An alphanumerical character is used for
a
to indicate the drive capacity.
1 : 100GB
2 : 200GB
4 : 400GB
8 : 800GB
An alphanumerical character is used for
b
to indicate the number of drives and the RAID type.
H : x1
M : x2 (RAID1)
P : x4 (RAID5)
S : x6 (RAID1+0)
An alphanumerical character is used for
c
to indicate the drive size.
C or E : 2.5inch
D or F : 3.5inch
*1: An alphanumerical character is used for
a
to indicate the host interface type.
C : FCoE
F : 8Gbit/s FC
H : 16Gbit/s FC
L : 1Gbit/s iSCSI
S : SAS
Y : 10Gbit/s iSCSI
An alphanumerical character is used for
b
to indicate the number of ports on a host interface adapter.
2 : two ports
N
: two ports (without SFP+ modules)
□
Host interface adapter (x 1)
Host interface adapters are installed in the following locations at the rear of the controller enclosure:
●
single-controller type
Host Interface (Product ID: ETCH
a
1
b
, ETEH
a
1
b
(*1)
)
Thin Provisioning Feature (Product ID: ETCL
a
T, ETEL
a
T
(*1)
)
□
License label (x 1)
□
Release tie (x 1)
*1: An alphanumerical character is used for
a
to indicate the target model.
8 : for ETERNUS DX80 S2 Disk storage system
9 : for ETERNUS DX90 S2 Disk storage system
●
dual-controller type
When one host interface adapter is purchased, the host interface
adapter is installed in the location that is indicated by .
When two host interface adapters are purchased, the host interface
adapters are installed in the locations that are indicated by
and by .
When two host interface adapters are purchased, the host interface
adapters are installed in the locations that are indicated by .
When four host interface adapters are purchased, the host interface
adapters are installed in the locations that are indicated by
and by .