Fujitsu Eternus DX90 S2 - Chapter 2 Setting up the ETERNUS DX; Common Settings; Setting the To-Server Connection Type (Setting the SAS Port Parameters); Creating the Server Accessible LUN Groups (Setting the LUN Groups)

Chapter 2
Setting Up the ETERNUS DX
2.1 Common Settings
This section explains the settings required for all server OSes, regardless of the connection configuration.
See the "ETERNUS Web GUI User's Guide" for details of how to set up and operate ETERNUS Web GUI.
2.1.1 Setting the To-server Connection Type (Setting the SAS Port Parameters)
For each connection configuration, set the indicated items only. All other parameters should be left on their
default values.
Table 2.1 SAS port parameter settings
Parameter
Solaris OS, Windows
®
, Linux, VMware ESX
Reset Scope I_T_L (Default value)
Release Reservation if Chip is Reset Disable (Default value)
2.1.2 Creating the Server Accessible LUN Groups (Setting the LUN Groups)
Create LUN groups (Affinity Group) for the server to access. Refer to "Connectivity (Basic Information)" in
"ETERNUS Web GUI User's Guide" for details, and set the LUN groups.
When the server OS is Windows
®
, Linux, or VMware ESX, assign SCSI LUN numbers starting from LUN0 in
ascending order.
The server cannot recognize the ETERNUS DX LUNs unless they are assigned in this order.
This restriction does not apply when the server is running a Solaris OS.
8
FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection-
Copyright 2014 FUJITSU LIMITED
P3AM-5352-11ENZ0