Fujitsu Eternus DX90 S2 - Power on Procedure

Power On Procedure (1)
 The ETERNUS DX S2 systems can be Powered On directly
from the Controller Enclosure
 Push the Power Switch
• The "Power" LED of the CE switches on
• The power on sequence takes about 2 minutes
• If everything is OK, the green Ready LED in
the CE and the green Power LED in the DE
switch on
Copyright Fujitsu Technology Solutions, Release August 2011
Hardware Installation ETERNUS DX80 S2 and DX90 S2
Power O
Fault O
Active O
Power O
Ready O
Fault O
Maint/ID O
Cache O
15