System expansio ns
Removing the SmartCard reader
SmartCardread er
► Open the casing (see "Opening the casing", Page 34).
► If a PCIe board is installed, you must rem ove the cross piece and PCIe
board (see "
Removing the board", Page 60).
1
3
3
4
2
► Disconnect the cable from the SmartCard reader (1) and from the mainboard (2).
► Undo the screws ( 3).
► Lift the SmartCard reader from the carrier (4).
► When required, reinstall the cross piece and the P C Ie board (see "
Installing the board", Pa ge 58 ).
► Clo se the casing (see "
Closing the ca sing", Page 62).
Ensure tha t cables are not trapped between th e casing and the components.
Fujitsu 39
To Next Page
Loading...
