En-3
NAME OF PARTS
Remote controller
Display
1
MODE button
2
10°C HEAT button
3
SET TEMP. button (
/
)
4
ECONOMY button
5
SLEEP button
6
FAN button
7
START/STOP button
8
SET button
9
SWING button
0
TIMER MODE button
A
TIMER SET (
/ ) button
B
CLOCK ADJUST button
C
RESET button
D
TEST RUN button
●
This button is used when installing the condi-
tioner, and should not be used under normal
conditions, as it will cause the air condi-
tioner’s thermostat function to operate incor-
rectly.
●
If this button is pressed during normal op-
eration, the unit will switch to test operation
mode, and the Indoor Unit’s OPERATION In-
dicator Lamp and TIMER Indicator Lamp will
begin to ash simultaneously.
●
To stop the test operation mode, press the
START/STOP button to stop the air condi-
tioner.
E
Signal Transmitter
Display panel
To facilitate explanation, the accompanying illustration has
been drawn to show all possible indicators; in actual oper-
ation, however, the display will only show those indicators
appropriate to the current operation.
F
Temperature SET Display
G
Operating Mode Display
H
SLEEP Display
I
Transmit Indicator
J
Fan Speed Display
K
SWING Display
L
Timer Mode Display
M
Clock Display
Some indoor units may not be equipped with the functions
corresponding to all of the buttons on this remote control-
ler. The indoor unit will beep and the OPERATION, TIMER
and ECONOMY lamp ash when a remote controller but-
ton is pressed if the function is not available.
To Next Page
Loading...
