En-4
Load Batteries (R03/LR03 × 2)
1
Press and slide the battery compartment lid on the
reverse side to open it.
Slide in the direction of the arrow while pressing the mark.
2
Insert batteries.
Be sure to align the battery polarities ( ) correctly.
3
Close the battery compartment lid.
Set the Current time
1
Press the CLOCK ADJUST button.
Use the tip of a ball-point pen or other small object to press the button.
2
Use the TIMER SET ( / ) buttons to adjust the
clock to the current time.
button: Press to advance the time.
button: Press to reverse the time.
(Each time the buttons are pressed, the time will be advanced/reversed in
1 minute increments; hold the buttons depressed to change the time quickly
in 10 minute increments.)
3
Press the CLOCK ADJUST button again.
This completes the time setting and starts the clock.
To Use the Remote controller
●
The Remote controller must be pointed at signal receiver to operate correctly.
●
Operating Range: About 7 meters.
●
When a signal is properly received by the air conditioner, a beeping sound will be
heard.
●
If no beep is heard, press the Remote controller button again.
Remote controller Holder
1
Mount the
Holder.
Screws
2
Set the Remote con-
troller
Insert
Press in
3
To remove the Remote con-
troller (when use at hand).
Slide up
Pull out
PREPARATION
CAUTION!
●
Take care to prevent infants from acciden-
tally swallowing batteries.
●
When not using the Remote controller for
an extended period, remove the batteries to
avoid possible leakage and damage to the
unit.
●
If leaking battery uid comes in contact
with your skin, eyes, or mouth, immediately
wash with copious amounts of water, and
consult your physician.
●
Dead batteries should be removed imme-
diately and disposed of properly, either in a
battery collection receptacle or to the appro-
priate authority.
●
Do not attem pt to recharge dry batteries.
Never mix new and used batteries, or
batteries of different types.
Batteries should last about 1 year under
normal use. If the Remote Controller’s
operating range becomes appreciably re-
duced, replace the batteries and press the
RESET button with the tip of a ballpoint
pen or other small object.
To Next Page
Loading...
