Removing and inst alling components
during servicing
Preparing to remove components
If you are going to remove or change system components, prepare for t he removal as follows:
Please obse rve the safety information in chapter "Important note s", Page 13.
Remove the power plug from the mains outlet !
► Switch the device off.
The device must not be in energy-saving mode !
► Close the LCD screen.
► Remove all the cables
from the d evic e.
► Turn the device over and place it on a stable, flat and clean surface. If necessary, lay an
anti-slip cloth on this surface to prevent the device from being scratched.
► Remov e the battery
(see "
Removing a battery", Page 33 ).
Installing and removing memory expansion
MemorymoduleMainmemoryRemovingmemor
y
Systemexpansi
on
Systemexpansi
on
If you are asked by the Ho tline/Service Desk to remove and install the memory
expansion yourself, proceed as follows:
Please obse rve the safety information in chapter "Important note s", Page 13.
When installing/removing memory modules, the battery must be removed from
the notebook and the notebook must not be connected to the pow er supply,
see "
Preparing to remove components", Page 69.
Only use mem ory expansion modules that have been approved for your
notebook (see "
Technical data", Page 84).
Never use force whe n installing or re moving a memory extension.
Make sure that foreign objects do not fall into the memory extension compartment.
You must open the service compartment t o remove or install a memory module. On some de vices,
opening the compartment may exp ose other components. These components should be removed
and replaced o nly by authorised specialists. Therefore, be sure to observe the following:
Individual components can be come very hot during operation. Therefore, we
recommend that you wait on e hour after switching off the notebook before removing
or installing memory modules. Otherwise, there is a risk of suffering burns!
As some components are exposed that are sensitive to st atic electricity, please take
note of chapter "
Notes on installing and removin g boards and components", Page 68.
Fujitsu Technology Solutions 69
To Next Page
Loading...
