Removing and in stalling componen ts
during servicing
Installing the h ard disk
► If necessary, attach t he shock ab sorber kit to the underside of the new hard disk.
2
1
► Attach the hard disk connector to the hard disk (1).
► Carefully put the hard disk into the hard disk compartment (2).
2
1
► Place the cover in the correct mounting position (1).
► Fasten the c over with the screw (2).
► Install th e battery again (see "
Installing battery", Pa ge 18).
► Turn the notebook the right way up and place it on a flat surface.
► Reconnect the cables that you disconnected previously.
30 A26391-K274-Z220-1-7919, edition 1
To Next Page
Loading...
