42
- LIFEBOOK Security/Application Panel
Setting Supervisor Password
You must have set a supervisor password before setting any user passwords. The supervisor password can
bypass the user password. Depending upon your operating system, use the appropriate procedure below.
1 Go to the Start menu.
2 Select All Programs.
3 Select Accessories, then select Run.
4 Type in:
C:\Program Files\Fujitsu\Security Panel Application\Supervisor\FJSECS.EXE, then press [Enter]
5 Follow the on-screen instructions to set the Supervisor password.
Setting User Password
1
Go to the Start menu.
2 Click on Programs (or All Programs).
3 Click on Security Panel Application and Set User Password.
4 Follow the on-screen instructions to set the user password.
T
HE PURPOSE OF SUPERVISOR PASSWORD IS TO BE ABLE TO BYPASS THE USER PASSWORD IN CASE
THE USER PASSWORD IS FORGOTTEN. THE SUPERVISOR PASSWORD ALONE WILL NOT LOCK THE
SYSTEM. YOU MUST SET BOTH THE SUPERVISOR AND USER PASSWORDS FOR THE SECURITY PANEL TO
WORK.
Y
OU MAY CHANGE OR REMOVE THE SUPERVISOR OR USER PASSWORD BY REPEATING THE STEPS
DEFINED ABOVE.
To Next Page
Loading...
