This rubber base cover is designed so that you can use your
system either in notebook configuration or in tablet configu-
ration.
Figure 1. Rubber Base Cover (top, empty)
Installing a system in the cover
To install your system into the rubber base cover:
1. Press the latch button in and open the display so that it is
in notebook configuration.
2. Position the system so that the two front corners are
aligned with the two front corners of the base cover.
3. Gently pull the base cover backwards until the front cor-
ners of the system fit snugly into the corners of the cover.
(Figure 2)
Front of Cover
Rear of Cover
INSTRUCTIONS
LifeBook T5010 Rubber Base Cover
Fujitsu America, Inc.
Rubber Case FPC58- 2691-01.fm Page 1 Thursday, January 14, 2010 4:29 PM
To Next Page
Need help?
General