Working with the noteb ook
Setting up the port replicator
Select a suitable location for the Port Replicator before setting it up.
Follow the instructions below when doing so:
• Never place the port replicator on a soft surface (e.g. carpeting, upholstered furniture, bed ).
This can block the air vents of the note book and cause overheating and damage.
• Place the port replicator on a stable, flat and non-slip surface. Ple ase note that the
port re plicator’s rubber feet may mark certain types of surfa ce.
• Never place the port replicator and the mains adapter on a heat-sensitive surface.
• Do not expose the port r eplicator to extreme environmental conditions.
Protect the port replicator from dust, humidity and heat.
Connecting the mains adapter to the Port R eplicator
3
1
2
► Connect the power cable (1) to the power
adapter provided for the device, see
chapter "
Technical data", Page 72.
► Plug the power cable into the mains
socket (2).
► Connect the mains adapter cable to the D C
jack (DC IN) of the Port Replicator (3).
When the notebook is connected to a Port Replicato r, the operating system creates
a hardware profile for the "Docked" mode. In this profile, for example, the setting is
saved as to which monitor was last used for output. This profile will be loaded, as
soon as th e notebook is connected to a Port Replicator of the same type.
42 Fujitsu
To Next Page
Loading...
