En-31
EnglishFrançaisDeutschEspañol
■ INPUT 1 Mode (RGB only)
You can select the DIGITAL RGB terminal or RGB (analog) terminal for
the INPUT 1 input terminal.
Select by pressing the and adjustment buttons.
The factory default setting is [Analog].
■ Component Input (VIDEO only)
You can select HD (High Definition: 720P, 1080I) or SD (Standard: 480P,
480I) for the INPUT 3 component input signal.
Select by pressing the and adjustment buttons.
The factory default setting is [SD].
■ Language
You can select the language of the menu display.
Select by pressing the and adjustment buttons.
■ Video Standard (VIDEO only)
You can select the video broadcasting format. For normal use, set on
[AUTO]. When set on [WIDE], the picture becomes elongated sideways
(the aspect ratio of the picture is about 16:9).
Select by pressing the and adjustment buttons.
The factory default setting is [AUTO].
■ Source Status
You can select the method of displaying the status of the input source as
follows.
1) All
The source and mode status are displayed. The display disappears
after a few seconds. When there is no signal, the [No Signal]
message is constantly displayed.
2) No Signal
The [No Signal] message is constantly displayed only when there is
no input signal.
3) No Display
The input source status is not displayed.
Select by pressing the and adjustment buttons.
The factory default setting is [All].
■ Blank Screen
You can select whether to have blue or black for the background color when
there is no image input signal.
Select by pressing the and adjustment buttons.
The factory default setting is [Blue].
■ Overscan
When there is interference at the top of the video screen, etc., you can
adjust the picture so that that part is not visible.
Select by pressing the and adjustment buttons.
The factory default setting is [Standard].
■ 3D Y/C
In the case of still images, the image becomes clearer when set on [On].
In the case of VTR (moving images), if the image is distorted, set on [Off].
This function can only be enabled when an NTSC video signal is input into
the VIDEO terminal for VIDEO INPUT.
Select by pressing the and adjustment buttons.
The factory default setting is [On].
Setting the DISPLAY
(Language)
(Video Standard)
: Select
MENU
: Return
Language
En
g
lish
Fran
ç
ais
Es
p
añol
Italiano
Deutsch
: Select
MENU
: Return
Video Standard
AUTO
WIDE
NTSC
PAL
SECAM
PAL–M
PAL–N
NTSC–4.43
To Next Page
Loading...